Error updating to v3 [OSMC / Debian]

[pinn]

Just to confirm: are you attempting UI access with a browser running on the same device running SABnzbd?

hi. no it's headless. I'm using another PC on same network

[OneCD]

OK, then you need to put the IP address of the device hosting SABnzbd into your browser address bar.

If you use localhost or 127.0.0.1 in your browser, this is a request to your PC, not the server.

[pinn]

OK, then you need to put the IP address of the device hosting SABnzbd into your browser address bar.

If you use localhost or 127.0.0.1 in your browser, this is a request to your PC, not the server.

Doh! APologies as it's a while since I've done a clean set up.

Progress - it says 'file not found' now.

[OneCD]

Great!

What is the URL you’re now using in your browser?

[pinn]

http://192.168.0.10/8080/sabnzbd

I'm also using noip so it's accessible from outside network but that's currently not working either

[OneCD]

http://192.168.0.10/8080/sabnzbd

Your address syntax is close, but not quite right.

The IP address and port number should be separated by a colon :

Try 192.168.0.10:8080

[pinn]

192.168.0.10 refused to connect.

[pinn]

strange - it just started working. I just opened kodi webinterface at 192.168.0.10 then tried sab again and works both on local and external network
Cheers for the help as this was really annoying me!

[OneCD]

Good work.

[pinn]

Spoke to soon, while it is running , it is running v1.1.1 . I used these instructions:

From the standard Debian contrib repository
First make sure you have the Debian repository contrib activated. Then

sudo apt-get install sabnzbdplus

I then used the git instructions on the same page and all installed. I can run sabv3 from directory fine but how can I set v3 to run at boot rather than v1?

Thanks