Stuck at 99% repairing
Forum rules
Help us help you:
Help us help you:
- Are you using the latest stable version of SABnzbd? Downloads page.
- Tell us what system you run SABnzbd on.
- Adhere to the forum rules.
- Do you experience problems during downloading?
Check your connection in Status and Interface settings window.
Use Test Server in Config > Servers.
We will probably ask you to do a test using only basic settings. - Do you experience problems during repair or unpacking?
Enable +Debug logging in the Status and Interface settings window and share the relevant parts of the log here using [ code ] sections.
-
- Full Member
- Posts: 211
- Joined: October 31st, 2012, 9:35 pm
Stuck at 99% repairing
I have one job that's stuck at 99% repairing for the longest time. This affects the other jobs because they are in "waiting" state. What gives?
Re: Stuck at 99% repairing
Depending on your hardware repair can take a very long time.
If you suspect it's crashed somehow then do this:
Use the operating system's tools to stop a task called "par2" (or starting with "par2").
SABnzbd will flag the job as failed.
Then either retry or delete the job.
If you suspect it's crashed somehow then do this:
Use the operating system's tools to stop a task called "par2" (or starting with "par2").
SABnzbd will flag the job as failed.
Then either retry or delete the job.
-
- Full Member
- Posts: 211
- Joined: October 31st, 2012, 9:35 pm
Re: Stuck at 99% repairing
Oh this is definitely not because of hardware. It's been like this for around 2 days already. Ok, I'll try that.
-
- Full Member
- Posts: 211
- Joined: October 31st, 2012, 9:35 pm
Re: Stuck at 99% repairing
So I stopped the par2 process and for some reason it did fix the job in question (it did not mark it as failed). Any reason why it did that?
Re: Stuck at 99% repairing
We have no control over what par2 does and little knowledge about its internals