SABnzbd+ exit code 2

[citricemperor]

I can start SABnzbd via the GUI but when I try it using this commands, it fails:

Code: Select all

sudo /etc/init.d/sabnzbdplus start

or

Code: Select all

sudo service sabnzbdplus start

The command

Code: Select all

systemctl status sabnzbdplus.service

gives me:

[OneCD]

You might try launching SABnzbd with the username you want to run SABnzbd as.

If your username is 'pi', then:

Code: Select all

sudo systemctl start [email protected]

To check:

Code: Select all

sudo systemctl status [email protected]

[sander]

Is this the same as viewtopic.php?f=16&t=23412#p115950 ?

[citricemperor]

You might try launching SABnzbd with the username you want to run SABnzbd as.

If your username is 'pi', then:

Code: Select all

sudo systemctl start [email protected]

To check:

Code: Select all

sudo systemctl status [email protected]

I tried it, but I end up with:

[citricemperor]

Is this the same as viewtopic.php?f=16&t=23412#p115950 ?

I tried the solution justgosh suggested, but that are exactly the steps I took to install SABnzbd+. The only difference here, is that I can't run

Code: Select all

sudo add-apt-repository ppa:jcfp/nobetas

or

Code: Select all

sudo add-apt-repository ppa:jcfp/sab-addons

but this is not my problem since no-one with a Raspberry Pi can run add-apt-repository.

[jcfp]

Is this the same as viewtopic.php?f=16&t=23412#p115950 ?

Nope, this user is using the normal init.d script.

TS: see if there's anything useful in the program log files (under .sabnzbd/logs/ in the home dir of the configured user). Might also want to post your /etc/default/sabnzbdplus, and check (sudo netstat -lntep) there's nothing else on the port for sabnzbd (defaults to 8080).