Hi,
I have installed sabnzbd with the sherpa script on my QNAP NAS TS-459 Pro (lastes QTS4.2). Installer runs fine and sabnzbd is starting normally. However after downloading has started sabnzbd stops working after some time. Sometimes it works for a few hours, sometimes shorter. After restarting manually via SSH sabnzbd runs again for some time and then quits. Any clue what could go wrong?
Any help appreciated.
Regards,
Willem
Sabnzbd stops working on Qnap NAS
Forum rules
Help us help you:
Help us help you:
- Are you using the latest stable version of SABnzbd? Downloads page.
- Tell us what system you run SABnzbd on.
- Adhere to the forum rules.
- Do you experience problems during downloading?
Check your connection in Status and Interface settings window.
Use Test Server in Config > Servers.
We will probably ask you to do a test using only basic settings. - Do you experience problems during repair or unpacking?
Enable +Debug logging in the Status and Interface settings window and share the relevant parts of the log here using [ code ] sections.
Re: Sabnzbd stops working on Qnap NAS
Hi Willem,
I'll include a link to your original post to help everyone get up to speed: https://forum.qnap.com/viewtopic.php?p=640768#p640768
I'll include a link to your original post to help everyone get up to speed: https://forum.qnap.com/viewtopic.php?p=640768#p640768
Stuff I like: Apache bash cron DD-WRT Debian DNSMasq Entware FireFox GitHub ImageMagick Kate KDE LibreELEC Netrunner NFS NVIDIA OpenVPN Orvibo-S20 pfSense Python Raspberry-Pi RAID SABnzbd Transmission Usenet VirtualBox Watcher3 XFCE
Re: Sabnzbd stops working on Qnap NAS
Could you send me the whole log at [email protected]?
If you like our support, check our special newsserver deal or donate at: https://sabnzbd.org/donate
Re: Sabnzbd stops working on Qnap NAS
I think I have found the solution. My NAS TS-459 Pro is of an older type. I noticed already for some time a high usage of RAM and Processor (showing orange in nas resource monitor), perhaps due to all the updates the NAS has got during the years. In another forum I read a description how to double the internal memory of this nas (from 1GB to 2 GB). I was able to acquire a 2GB memory module for little money and after installing the 2GB module it appears that the nas is running much smoother! RAM usage stays much lower and SABnzbd keeps running until now!
Re: Sabnzbd stops working on Qnap NAS
Thanks Willem - just in time to update to 2.3.1.
Stuff I like: Apache bash cron DD-WRT Debian DNSMasq Entware FireFox GitHub ImageMagick Kate KDE LibreELEC Netrunner NFS NVIDIA OpenVPN Orvibo-S20 pfSense Python Raspberry-Pi RAID SABnzbd Transmission Usenet VirtualBox Watcher3 XFCE