SabNZB Errno 99 - No socket could be created - Won't launch (Unraid)
Posted: March 20th, 2020, 3:43 pm
Hello,
I was getting an errno 99 code when trying to connect to my usenet servers and found a post saying to turn off Ipv6. So I did that. Now unraid will not launch my Sab docker at all and I am getting the same erno99 code.
It's not letting me post the code because i cant post links as a new user? But here's the errors
2020-03-20 13:41:16,168::ERROR::[_cplogging:219] [20/Mar/2020:13:41:16] ENGINE Error in HTTP server: shutting down
Traceback (most recent call last):
File "/opt/sabnzbd/cherrypy/process/servers py", line 207, in _start_http_thread
self.httpserver.start()
File "/opt/sabnzbd/cherrypy/wsgiserver/__init__ py", line 2012, in start
raise socket.error(msg)
error: No socket could be created -- (('::1', 8090, 0, 0): [Errno 99] Cannot assign requested address)
I honestly am at a loss at this point and not sure what I need to do because I cant get back into the gui to access the sab settings to turn back on ipv6. Is there some command i can type in the config that will let me back into the gui and get everything working again? Any help would be greatly appreciated!!
I was getting an errno 99 code when trying to connect to my usenet servers and found a post saying to turn off Ipv6. So I did that. Now unraid will not launch my Sab docker at all and I am getting the same erno99 code.
It's not letting me post the code because i cant post links as a new user? But here's the errors
2020-03-20 13:41:16,168::ERROR::[_cplogging:219] [20/Mar/2020:13:41:16] ENGINE Error in HTTP server: shutting down
Traceback (most recent call last):
File "/opt/sabnzbd/cherrypy/process/servers py", line 207, in _start_http_thread
self.httpserver.start()
File "/opt/sabnzbd/cherrypy/wsgiserver/__init__ py", line 2012, in start
raise socket.error(msg)
error: No socket could be created -- (('::1', 8090, 0, 0): [Errno 99] Cannot assign requested address)
I honestly am at a loss at this point and not sure what I need to do because I cant get back into the gui to access the sab settings to turn back on ipv6. Is there some command i can type in the config that will let me back into the gui and get everything working again? Any help would be greatly appreciated!!