Sabnzbd setup with NZBgeek
Forum rules
Help us help you:
Help us help you:
- Are you using the latest stable version of SABnzbd? Downloads page.
- Tell us what system you run SABnzbd on.
- Adhere to the forum rules.
- Do you experience problems during downloading?
Check your connection in Status and Interface settings window.
Use Test Server in Config > Servers.
We will probably ask you to do a test using only basic settings. - Do you experience problems during repair or unpacking?
Enable +Debug logging in the Status and Interface settings window and share the relevant parts of the log here using [ code ] sections.
-
- Newbie
- Posts: 1
- Joined: April 15th, 2019, 11:20 am
Sabnzbd setup with NZBgeek
I have successfully set up NZBgeek in the past, but I switched hard drives and now have to do it again. I can't for the life of me remember how I set it up last time. I am stuck on the setup wizard where it asks for host, username, and password. I am assuming the username and password are my NZBgeek username and password. However I have no idea what to enter for host and I get either an authentication failure or an address not available failure when I test the server. Does anyone know what to enter for the host and if there are any other settings I have to change? Thanks.
Re: Sabnzbd setup with NZBgeek
In the wizard, SAB asks for your newsserver. And NZBgeek is NOT a newsserver, but an indexer ...
So: what is your newsserver ... ?
So: what is your newsserver ... ?