Hi,
I wanted to change in the sabnzbd settings the port that the service was accessible to, from 8080 to 9090 (because I wanted to use 8080 for another service on my Synology DS920Plus NAS DSM 7.2.1-69057 Update 1).
But once I did it, save the changes and try to reload the page MY_NAS_IP_ADDRESS:9090 nothing loads.
Tried with 8080 but nothing anymore.
When I open the Package Center it is show this message : "Failed to start SABnzbd. Please try again later or contact the package developer"
And gives me the choice of "Repair", I clicked it, it installs the package, and comes back to "Repair".
I don't want to uninstall because of the hassle of all the settings that I have.
Can someone tell me where the port of the sabnzbd service is stored (file or database entry) so that I can change it back ?
Thanks!
After port change 8080-->9090, can't access webinterface anymore
Forum rules
Help us help you:
Help us help you:
- Are you using the latest stable version of SABnzbd? Downloads page.
- Tell us what system you run SABnzbd on.
- Adhere to the forum rules.
- Do you experience problems during downloading?
Check your connection in Status and Interface settings window.
Use Test Server in Config > Servers.
We will probably ask you to do a test using only basic settings. - Do you experience problems during repair or unpacking?
Enable +Debug logging in the Status and Interface settings window and share the relevant parts of the log here using [ code ] sections.
Re: After port change 8080-->9090, can't access webinterface anymore
You can only reach it through SSH:
/volume1/@appdata/sabnzbd/sabnzbd.ini
You cannot change the port on DSM, this is a limitation of Synology. Not much we can do about it.
/volume1/@appdata/sabnzbd/sabnzbd.ini
You cannot change the port on DSM, this is a limitation of Synology. Not much we can do about it.
If you like our support, check our special newsserver deal or donate at: https://sabnzbd.org/donate
Re: After port change 8080-->9090, can't access webinterface anymore
Thanks for your help, I found the config file at : /volume1/@appdata/sabnzbd/config.ini
Changed it from 9090 to 8080
But I was still getting the "This site can't be reached. 192.168.1.XX refused to connect" from my browser.
So went to the Package Center and clicked "Repair".
Now it's all good
Changed it from 9090 to 8080
But I was still getting the "This site can't be reached. 192.168.1.XX refused to connect" from my browser.
So went to the Package Center and clicked "Repair".
Now it's all good