SABnzbd Forums

Hi all,

recently downloads which are being passed from Couchpotato to SAB are sticking at 100%, with no errors in the logs, and leaving just a small _ADMIN_ folder in the incomplete folder. Downloads are fine from SickBeard.

I don't know where to start troubleshooting, can anyone advise please?

Is anything actually downloaded?
Maybe you should enable "Abort jobs that cannot be completed" in Config->Switches.

Sab says so yes, when I hover over the first item it says Downloading, but when I hover over the second item it says "waiting".

There's a folder with parts of downloads in it in the destination with ".nzb.gz" file and a SABNZBD_Attrib file and a SABnzbd_nzo_vvR9WJ file.

Looking at the logs it looks to have downloaded the articles yes.

No error messages in the log?

nope! I scoured it

What happens if you set the job's "priority" to "stop"?

It appears to refuse to allow me to set the status to "stop", the dropdownbox immediately reverts back to Normal and nothing appears to have changed. It's happened again on a Couchpotato one today

Click on the job in the queue.
You should see a list of files. If none are visible then there's some error in SABnzbd.
Try setting priority to "Stop" there and click "Save".

I clicked the download and there were no files. Are you sure there'd be files even if it's at 935MB of 935MB?

I can't change the priority to stop on that screen, there is only Default, High, Normal and Low.

Very weird.
If it's the only job left, I suggest you do a "Queue Repair" from the Status page.

Same problem.

Had one hang up early in the week at 100%, sat there for a few days and corrected itself.

Now I have seven or eight, all at 100%. If I click on the item, it shows no files listed. SAB had no errors.

Must be a bug then.
You can finish the jobs by changing the priority to "Stop".

Same issue here... no files, 100% downloaded. Tried queue repair. Can't change to stop because it doesn't stick.

colinize wrote:Same issue here... no files, 100% downloaded. Tried queue repair. Can't change to stop because it doesn't stick.

Yep. Exactly the same here. Click "stop" in the drop down, SAB thinks for a moment, then goes back to whatever setting the file had previously (doesn't stay at stop)

Really annoying.

Anyone ever figure this out? I've got a number of them stuck, they seem to be piling up and then every now and them at seeming random intervals, one will finish.

Not able to change the value to 'stop' either, the GUI just resets the value back to what it was.