SABnzbd Forums

Hi,

since 1.2.1 beta1 i get this error on all files with password:

WARNING: Paused job "xxx" because of encrypted RAR file (if supplied, all passwords were tried).

On 1.2 stable only from time to time.

Password of course is correct.

Greetings
mch

Could you send me an example NZB and the password at [email protected]?

Sent ...

same by me .. an their is a " +" sign added to the filname .. the password in {{xyz}} is shown correctly but not used for encrypting ...
i also sent a nzb-file with PW in filename ...
the same nzb-file works in 1.20 final correct..

Thanks.
Not near a computer today, but will try tomorrow!

if encryption detection is disabled unpacking then fails

@Gurbil, could you send me an example NZB to [email protected]?

I tried with the NZB's that both other users supplied and those caused no problems.

Hi safihre,

I have the same problem as the guys above and I could narrow it down a bit.
It only happens (for me at least) if you use NameOfFile{{Password}} to automatically add the password to the download. If i add the password manually it works fine.
This is with encryption detection disabled.

If encryption detection is enabled it always pauses the dl and shows the "...because of encrypted RAR file (if supplied, all passwords were tried)" error. If the pw is manually added I can resume the download and it unpacks fine.

Something is probably wrong with the encryption detection and the NameOfFile{{Password}} function.

Rgrds,
Hammer

Hammer wrote:Hi safihre,

I have the same problem as the guys above and I could narrow it down a bit.
It only happens (for me at least) if you use NameOfFile{{Password}} to automatically add the password to the download. If i add the password manually it works fine.
This is with encryption detection disabled.

If encryption detection is enabled it always pauses the dl and shows the "...because of encrypted RAR file (if supplied, all passwords were tried)" error. If the pw is manually added I can resume the download and it unpacks fine.

Something is probably wrong with the encryption detection and the NameOfFile{{Password}} function.

Rgrds,
Hammer

Yes, thats the problem. I got the same issues with NameOfFile{{Password}} files

Fixed it, will be in the next test-release

I have a similar problem. It happens during a retry of an unpack, When I put in the proper password (tested it through winrar) during a retry of a download (that stopped during unpack because the password was missing) it keeps on comming back with the message tellimng it requires a password. I use the 1.2.1RC1. When I unpack with the same password with winrar manuualy I have no problem unpacking the rar files.

So to be clear: it was not detected during download that the download was encrypted and no password was set?
And then when you retry, it fails during Unpack?
What error does it show?

I think I found and fixed the issue, it indeed failed on Retry due to incorrect passing of the password.