Page 1 of 1
ipv6 issue
Posted: December 12th, 2023, 4:26 am
by wafa
Hi,
I'm trying to connect via ipv6 on qnap, ver 4.0.1 with no luck. I've been trying to change in config "SABnzbd-Host" to "::" (without quotes). It get accepted but after restart "0.0.0.0" is back. Tried to change config.ini manually, the same after restart. Any ideas?
Thanks
Re: ipv6 issue
Posted: December 12th, 2023, 4:50 am
by sander
How is SABnzbd started? You can see in SABnzbd -> Config.
On one of my SAB instances, that Config page says
Code: Select all
"/usr/bin/sabnzbdplus" "--daemon" "--pidfile" "/var/run/sabnzbdplus/pid" "--server" "0.0.0.0"
... which hard-forces 0.0.0.0
Re: ipv6 issue
Posted: December 12th, 2023, 6:14 am
by wafa
Hi sander,
Thank you very much! You saved my day
Re: ipv6 issue
Posted: December 12th, 2023, 6:19 am
by sander
wafa wrote: ↑December 12th, 2023, 6:14 am
Hi sander,
Thank you very much! You saved my day
Good to hear, but how did you solve it?
Re: ipv6 issue
Posted: December 12th, 2023, 6:49 am
by wafa
Just deleted --server" "0.0.0.0" in the start parameter and changed SABnzbd-Host to "::"
Re: ipv6 issue
Posted: December 12th, 2023, 6:58 am
by sander
wafa wrote: ↑December 12th, 2023, 6:49 am
Just deleted --server" "0.0.0.0" in the start parameter and changed SABnzbd-Host to "::"
Good! So you found out where that start parameter was set?
Out of curiosity: why do you want SAB to be listening on IPv6? To allow easy access from Internet?