Do you experience problems during downloading?
Check your connection in Status and Interface settings window.
Use Test Server in Config > Servers.
We will probably ask you to do a test using only basic settings.
Do you experience problems during repair or unpacking?
Enable +Debug logging in the Status and Interface settings window and share the relevant parts of the log here using [ code ] sections.
I was unable to determine if there's anything I need to do inside of sab to make it use par2cmdline.
I have it installed, but don't see where I tell sab to use it. Is this something which is automatic or do I need to configure something inside of sab to use par2cmdline?
I have read the wiki and searched on the forums as well as looked over the configuration settings
inside of sab and I don't see anything which clearly states how this works.