Page 1 of 1
Webinterface stops !!!
Posted: March 21st, 2008, 4:40 pm
by fluefiske
Hello,
I have a question, i installed the new version Sabnzbd+ 0.3.4 on my Freecom datatank gateway 2TB and it runs perfectly (on port 1111), however my web interface wich is running on port 80 stopped working. Can anybody give me an explanation or is it perhaps a bug
With regards,
André van Stijn
Re: Webinterface stops !!!
Posted: March 21st, 2008, 5:19 pm
by shypike
I'm a bit confused.
You say to have it running on port 1111 and now the web interface does not respond to port 80.
That makes sense doesn't it? If you have the web interface running on port 1111, it will not respond to port 80.
Am I missing something here?
What does run on port 1111 ?
Re: Webinterface stops !!!
Posted: March 21st, 2008, 5:28 pm
by switch
He is running SABnzbd on port 1111. His "Freecom datatank" also runs a web-ui on port 80. The latter isn't working when SABnzbd is running.
I have seen this reported a few times now. I remember someone fixing it, but not sure what they did. It might have involved editing some config files for your Freecom web-ui, but I can't remember the specific details, sorry.
Re: Webinterface stops !!!
Posted: March 22nd, 2008, 3:05 pm
by fluefiske
fluefiske wrote:
switch wrote:
He is running SABnzbd on port 1111. His "Freecom datatank" also runs a web-ui on port 80. The latter isn't working when SABnzbd is running.
I have seen this reported a few times now. I remember someone fixing it, but not sure what they did. It might have involved editing some config files for your Freecom web-ui, but I can't remember the specific details, sorry.
This is correct, can't you please try to find it, i would like to use SabNzbd+ on my Freecom Datatank.