Support Forum

Hmmm, I can reproduce this now also in my laptop...

You can enable multi select in the top right of the queue.
Select them and delete at once.
Much faster I think.

You can also disable deletion confirmation in the Status and Interface settings window.

What error do you get when you try to download?
Can you start the test download from the Status window?

Since it has never been reported before, I have no clue what could cause this on your system.
In any case, just don't hit Repeat Test?

The Sorter can do the easy stuff only, to prevent having to support complex things which other apps are much better at.
For your use case the pre queue script sounds like a very simple solution. Could even ask some AI to write it for you. Just tell it to follow our documentation page.

Do Radarr and Sonarr also run in Docker?
And if so, what host did you use there?
Using localhost from within the Docker isn't going to work.
You should understand the Docker system first.

It still works. Just add a *

Probably a mistake was made in the French template.
Will investigate.

Indeed, there's only a pre queue script and not one after the job was added to the queue.
You might have to just set some cronjob to do it, unfortunately.

We used to remove them already in the queue, but the resulted in problems where the samples were part of the par2 set. So removing them would then force those jobs through repair or even fail if not enough blocks were available.

But why not use the Config Switches option to delete samples?
Might kee nfo files but those are tiny tiny.

What verison of Sab are you using and what email provider?
Which language do you use Sab in?

Check the Archive, it's in the bottom of the History.
There you should be able to see them.

No it hasn't been downloaded. Only the first article has been downloaded. The repair fails because the total available par2 isn't enough.

The options here are not going to change anything.

Or what is the message that is shown in history?
Is the job even set to Repair?

You can see the category parsing in the Debug logging of Sab. Then you can also see what was provided to us by Prowlar.

I'm not sure I fully understand your setup.